Outcast Steering blocks/cross threading

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.

PTM PETE

Member
Messages
33
Reaction score
24
Arrma RC's
When I first got my outcast the little red retaining pieces were really easy to screw in and out with my fingers, now after a couple of maintenance strip downs and one crash rebuild I cannot get these little round retainers to screw in square. They just cross thread the whole time

Just been looking and can't see an upgrade for this part, nice red alloy one would have been awesome.

Anyone else having similar trouble?
 
Hot Racing makes replacement ones not sure if they are better or not. A good tip for inserting the pillow ball retainers is to put some electrical tape about 3-4mm up your hex and use the tape to keep the hex from sliding through.
 
Hot Racing makes replacement ones not sure if they are better or not. A good tip for inserting the pillow ball retainers is to put some electrical tape about 3-4mm up your hex and use the tape to keep the hex from sliding through.

I was going to say that.

This is the only replacement I know of.
http://hot-racing.com/?partnumber=AON21M01;c=926

139400.jpg
 
Old Thread: Hello . There have been no replies in this thread for 90 days.
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.
Back
Top