Typhon Still a virgin.lol

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.

Gdub34

Active Member
Messages
682
Reaction score
416
Took a few pics of my minty 6s v5 typhon today after work before she gets dirty. She’s still a virgin that hasn’t even seen a lipo yet. Way better build quality than my 3s. This is her on my outdoor custom work bench. lol I did a battery figment check using two 5000 ma hard case 3s spektrum lipo batteries and they don’t fit without adjusting the rear body mounts. Two 2s 5000ma hard case spektrum lipo batteries fit easily though so I guess it’s 4s until I buy a good single 6s ic5 compatible pack for her. She’s in hibernation in my garage until I get my Exb super basher front bumper installed properly anyway.

C82673DB-4623-4DBE-8113-AD07B3EEE29B.jpeg


A0498EFF-C8D6-4606-885D-F922ED3FC044.jpeg


02E49765-84C7-470B-92BC-CD6EBB9583C2.jpeg


02563F36-6C8A-4AE5-9223-BE40EC7C7417.jpeg


79676FF6-3D30-46E0-B106-312915D9BF3D.jpeg


BCB7006E-5DB0-43DE-AC2F-B2C3A0F9ECFF.jpeg


19184B08-A821-41A0-8591-881F5DECE676.jpeg


26FC6ABF-CA48-46E7-8A17-B74BC6302411.jpeg


C46AC755-7915-433F-95C7-898A3D27B0CE.jpeg


2FE54E54-FEAC-4B0A-B2E8-EC9A955D663E.jpeg


EB9A7271-653F-472E-98E8-978D9F434464.jpeg


C98AEE25-6E60-4A54-B805-7737D973C484.jpeg
 
Not sur what your talkin about bro?
What do you mean?
Hinge pin plate? I have no clue what you mean? thanks
 
Last edited:
I just went through the same a couple weeks ago. The super basher bumper is a MUST and changes the look. I'm using 2 3s soft pack lipos from HRB they fit great.

T7.jpg
 
Are you putting a heatsink/dual fan setup on it? Really helped me drive it like I stole it.. the way it wanted to be driven.
 
SMC makes batteries specifically for Arrma battery trays, I think they have a nice 6s pack that would fit perfectly under stock body
 
Are you putting a heatsink/dual fan setup on it? Really helped me drive it like I stole it.. the way it wanted to be driven.
Doubt it because I’m leaving the gearing stock so I’m assuming I don’t need a motor fan correct? thanks
No it’s not, it’s utilizing the smaller hole because the center brace has not been upgraded.. so the top plate is flipped. This is correct.
Good to see the ace Arrma assembly goons got everything correct😊
 
Last edited:
Old Thread: Hello . There have been no replies in this thread for 90 days.
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.
Back
Top