Now that I’ve finally got everything back together and have been able to get a few runs in I’m getting some odd behavior (at least to me). With the single 6S 4000 30c pack it will only give me a flashing red light on the esc and with the two 3s packs it works fine most of the time will randomly go in reverse. Not sure where to start with any sort of diagnosing. Lol.
The only thing that I’ve touched electronics wise is when the servo was grinding the other night i ended up taking it out and retightening the screws that hold the body together. Could me Maby not plugging that connector in the same port on the receiver had messed with something?
Can i factory reset all those components and start fresh with programing everything?
The only thing that I’ve touched electronics wise is when the servo was grinding the other night i ended up taking it out and retightening the screws that hold the body together. Could me Maby not plugging that connector in the same port on the receiver had messed with something?
Can i factory reset all those components and start fresh with programing everything?