Talion Talion , Typhon , Senton stock and opt pinion gears ????

[3x9rtse]

OK , since the instructions are generic for the Armma 6s rigs , nowhere does it say what the optional pinion gears teeth are for them ( unless I'm not seeing it ) .
I have :
Senton 6s V3
Typhon 6s V4
Talion 6s V4

What I do see in the exploded views of each , it shows all of them having 12 tooth pinions stock , I put all the bags/tool kits together but after going through them , I have (2) 20 tooth and (1) 16 tooth . Which trucks are/where they for ?
Also I understand the 20 tooth are for speed runs and don't intend on using them , however I have another 15 and 16 tooth Mod gears from my Losi SCTE 3.0 I'm not using , figured I'd put them into these rigs to get some more speed out of them without worrying about the motor temps going up to high .

Thanks guys .

 

[bicketybam]

I'm almost positive that the V4 Typhon as well as any version Talion uses the 20t as the speed gear.

 

[Jimbobjr]

talion and typhon are the 20t. Senton must be the 16 but I'm not positive, don't own that model...

edit: Sorry, I'm slow today...

 

[3x9rtse]

Bicketey , what do you run on your Talion ?

 

[bicketybam]

Bicketey , what do you run on your Talion ?

I was running the 20t before I swapped motors. Now I'm running Hobbystar 4092 1730kv motor and a 24t pinion.

 

[jondilly1974]

I was running the 20t before I swapped motors. Now I'm running Hobbystar 4092 1730kv motor and a 24t pinion.

That thing is just crying to be jumped over the wire ??????

 

[3x9rtse]

So for an FYI , I just changed the stock pinions out on my V4 Typhon and Talion. They were as such stock :

Typhon V4 was a 14 tooth , went to a 16 tooth
Talion V4 was a 13 tooth , went to a 16 tooth