Kraton TBR full chassis skid plate

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.

headsock

Fairly New Member
Messages
9
Reaction score
3
Arrma RC's
Has anyone tried the TBR full chassis skid plate? Its 2.36mm.

Any good? Does it help with stiffness or is it too thin?

Does it come with new screws?

Was planning on doing a chassis over chassis skidplate/stiffener, but couldn't find one under SRP.

Kraton_TCS2_1_1024x1024.jpg
 
If it's just their plastic, I can't see it adding much strength to the chassis. It would just help it not get all dinged up from rocks and whatnot.
 
If it's just their plastic, I can't see it adding much strength to the chassis. It would just help it not get all dinged up from rocks and whatnot.

Good catch. Was under the impression it was alu, nothing stated in the description.
 
There is a post in here somewhere about someone getting one that was defective. I'll see if I can find it.
 
Thanks for the info guys. Scrapped that idea. Found a chassis below retail (ebay). But also might not do that either, and just use it as a spare.

Current plan is to make a top chassis brace.
 
I just ordered one of these skid plates plus both bumpers and rear mud guards. I’ll let yeall know how it goes when I get them.
 
Old Thread: Hello . There have been no replies in this thread for 90 days.
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.
Back
Top