Tekno eb48 2.0 diffs question

[dbd6604]

I know I know, there are better places to post this question, but this forum is much more active than any of the others I have found.

Just started building my eb48 2.0, and in the manual it shows the front and rear differentials being installed a certain direction, but in some of the videos I've seen people aren't installing them that way. Does the orientation even matter? I thought about it and I don't think that it does but please correct me if I'm wrong

 

[Jimbobjr]

As long as they are opposite one another and the chassis cut out is lined up with the ring gear ( tekno may cut both sides...) you should be good. Whether I'm looking at an open dif cover from the front or the rear of the car the ring is on the left side. ( looking from the rear, rear ring gear on drivers side (usa) looking from the front, ring gear on passinger side...)

 

[Grimbles]

@BashingBrian has a tekno EB, may be able to shed some light.

 

[BashingBrian]

@BashingBrian has a tekno EB, may be able to shed some light.

Sorry, I don't... I have MT410 but as @Jimbobjr says above, diffs always go opposite to one an other..