- Messages
- 2,184
- Reaction score
- 3,259
- Location
- The Boonies, South Carolina
- Arrma RC's
- Kraton 6s
- Kraton 4s
- Typhon 6s
Trying to change rear and steering hubs on my Typhon, the day the robot who put it together must love that Loctite it was soaked in all 4 axels. Don't have a butane torch (yet) and couldn't apply the heat directly on the hubs anyway, so before I strip that set screw I used my new Soldering kit and stuck it in there to heat it up, quickly put my hex key in it and used a small cheater bar to get it out, took me like an hour and a half to get 4 out, is there another way in case I got to do it again? I know they have to be secure but common, I had to clean the inside out with a pick before the allen got a bite on it.