Chevyfreak06
Active Member
- Messages
- 70
- Reaction score
- 27
- Arrma RC's
- Nero
Im looking for a nice took set to work on nero. What sizes do you think I'll need the most when it comes to the hex drivers.
Tools to work on nero
- Thread starter Chevyfreak06
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
links, including eBay, Amazon, and others.
Check out our thread, Tools for getting started in RC for some good tool set ideas.
I have buy an set from Hudy in the past. Starts with 1,5mm, 2mm, 2,5mm and 3mm.
For "-screws I have also a set from Hudy. I broke in 5 years just two 1,5mm blades.
But that was no problem because here I could by the blade separate. So I have some most usable blades as spare part in my box.
I have learned: Do not save money in case of tools, because cheap and garbage tools will damage the screws and you have more work and costs afterwards.
Regards,
lonee
For "-screws I have also a set from Hudy. I broke in 5 years just two 1,5mm blades.
But that was no problem because here I could by the blade separate. So I have some most usable blades as spare part in my box.
I have learned: Do not save money in case of tools, because cheap and garbage tools will damage the screws and you have more work and costs afterwards.
Regards,
lonee
