Kraton Tried to bind new receiver now ESC wont stop blinking red light

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.

NateDoggy

Fairly New Member
Messages
8
Reaction score
0
Arrma RC's
  1. Kraton 6s
Hey guys im new to RC, purchased a Kraton 6s a few days ago. Im trying to switch my receiver and transmitter to a radiolink.
i just binded the receiver and radio but my ESC wont stop blinking red light.
 
Hey guys im new to RC, purchased a Kraton 6s a few days ago. Im trying to switch my receiver and transmitter to a radiolink.
i just binded the receiver and radio but my ESC wont stop blinking red light.
You need to calibrate the ESC with the new radio
 
You need to calibrate the ESC with the new radio
so ive been trying, i turn everything off then hold A and turn on my esc. it makes a noise and starts blinking red again. i keep the radio on neutral and hit A again and it stops beeping and stops blinking
 
so ive been trying, i turn everything off then hold A and turn on my esc. it makes a noise and starts blinking red again. i keep the radio on neutral and hit A again and it stops beeping and stops blinking
Check your wiring to the receiver. Something sounds like it isn’t plugged in right.
 
Calibrate your TX with your receiver first.
Red blinking can mean a lot of things but mainly it lost communication with the receiver. Read the radio instruction on how to do it, then do the ESC calibration next. Make sure all the wires are plugged with right polarity and right port.
 
Old Thread: Hello . There have been no replies in this thread for 90 days.
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.
Back
Top