Trying to install LEDs to Senton

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.

LokoLuna

Member
Messages
5
Reaction score
0
Arrma RC's
  1. Senton 6s
I can't seem to find a receiver plug in for the lights. I'm kinda new to the RC world. So any help is appreciated.
 
I can't seem to find a receiver plug in for the lights. I'm kinda new to the RC world. So any help is appreciated.

based on no other info here you got the leds and not sure where to plug its port plug? or do not know if hte port plug is correct to plug into the Rx (receiver)

Plugging in to any rx port will always be lit on, unless you add a special device to make it go on/off wit ha module along with the ch 3 mode.

well hope that helped out. google on youtube how to add leds to the car many ways to go about it.
 
I don't have them yet. But I was looking around on the truck, and I couldn't find any receiver ports. Unless I'm overlooking it.
 
I don't have them yet. But I was looking around on the truck, and I couldn't find any receiver ports. Unless I'm overlooking it.
Upload a photo of your receiver. We'll take a look. You could also use a "Y" harness.
 
I'm not at home right now, but this is the set up.
 

Attachments

  • IMG_1176.PNG
    IMG_1176.PNG
    889.9 KB · Views: 76
  • IMG_1177.PNG
    IMG_1177.PNG
    1,007.6 KB · Views: 72
  • IMG_1178.PNG
    IMG_1178.PNG
    862.8 KB · Views: 76
That's the only area with wires beside the battery and motor.
 
Old Thread: Hello . There have been no replies in this thread for 90 days.
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.
Back
Top