Typhon Typhon 3s light rig

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.

drkern88

Active Member
Messages
195
Reaction score
210
Arrma RC's
  1. Typhon 3s
I created this front bracket part using Tinkercad and printed it. Then along with these cheapy led lights was able to make this light rig for my Typhon. Most importantly it's removable. It was more proof of concept than anything

20211229_211518.jpg


20211229_211319.jpg


20211229_211339.jpg


20211229_211359.jpg
 
Looks good! If it rolls over it may break, but printing in TPU should work fine. What did you print it out of?
 
Looks good! If it rolls over it may break, but printing in TPU should work fine. What did you print it out of?
Well it's PLA, the only filament I have currently. But I purposely made it shorter than the shock tower. Hopefully to mitigate some risk. However if I drove at night I wouldn't be doing any hardcore bashing
 
Old Thread: Hello . There have been no replies in this thread for 90 days.
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.
Back
Top