Typhon 3s shock tower covers

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
Somehow I jumped right over your thingiverse post, your design was exactly what I was thinking about, just a single cover for both towers. How well has it held up for you?
I didn't really test it. I just converted my Typhon to a Big Rock, but I see your point about making it thicker. With the Typhon, the front of those towers takes a beating when it flips.

I'll try to make that top a little thicker when I get time.

I think that TPU is going to be the best material for this because the PLA tends to shatter especially when cold.
 
I think that TPU is going to be the best material for this because the PLA tends to shatter especially when cold.
I haven't tried the TPU yet, was thinking about trying it with a print for some LED holders on the front of the Typhon, the PLA doesn't take those impacts very well. I do have some nylon on the shelf, always been a hassle to print with, but might work well in this application...
 
Old Thread: Hello . There have been no replies in this thread for 90 days.
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.
Back
Top