Typhoon 6s unresponsive stearing

[lilsavagerc]

I just bought a new servo and on my typhoon 6s it seers right when I turn on the car and the reciver and the car locks into place and the servo doesn’t turn when I try and turn with the reciver it stays locked in place and seems like the reciver is not sending any signal and the servo is plugged into port one and the motor in two

 

[GraniteFox]

Test the servo prior to install. Make sure all trims are at 0. Add servo horn while turned on and trims at 0. Depending on the receiver make sure it is not upside down. If all of the above are good possibly a AVC calibration issue. What radio? What receiver? What servo?