- Messages
- 1,755
- Reaction score
- 3,175
- Location
- Wenatchee, WA
- Arrma RC's
- 4x4-Mega
- BigRock 4x4
- Felony
- Granite
- Infraction
- Limitless
- Kraton 6s
- Outcast 4s
- Typhon 3s
- Voltage
- Thread starter
- #41
Coming soon later this week:. Arrma 4x4 complete center drive line tunnel that pairs perfectly with an updated design of the bell crank cover I just published.
Main tunnel cover is a single piece construction that replaces the center spine block so you run the battery strap through it and then slide the block in and the tunnel will slide over the center driveshaft, then it secures in place with the stock M4 screw from beneath the chassis. In addition there will be optional plates of two different sizes that can be chosen based on users needs that install into the center spine hexes to close the exposed portion on the other side between the motor and the receiver box. For the plates the user decides which size(es) of plates to use to close the gap which will vary based on motor size and chassis length.
Currently working out the small variances of the LWB chassis version to account for the center drive line bearing retainer but the SWB version is pretty much good to go. I'll publish once I am happy with both wheelbase versions and package it together with the bell crank cover so it's a complete set of enclosures for all moving parts in the chassis.
Main tunnel cover is a single piece construction that replaces the center spine block so you run the battery strap through it and then slide the block in and the tunnel will slide over the center driveshaft, then it secures in place with the stock M4 screw from beneath the chassis. In addition there will be optional plates of two different sizes that can be chosen based on users needs that install into the center spine hexes to close the exposed portion on the other side between the motor and the receiver box. For the plates the user decides which size(es) of plates to use to close the gap which will vary based on motor size and chassis length.
Currently working out the small variances of the LWB chassis version to account for the center drive line bearing retainer but the SWB version is pretty much good to go. I'll publish once I am happy with both wheelbase versions and package it together with the bell crank cover so it's a complete set of enclosures for all moving parts in the chassis.
Last edited: