What did you buy today?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
Where's the "what did you work on" post?
Haven't got there yet lol had kids soccer practice and just got done with dinner. Only be installing the bumper spring though as the v2 wing mount will wait until I can break one of my v1 mounts I'm running now. But nice to add some more color the my red white and blue Kraton setup😍
 
It's fixed but I forgot to attach it to the outcast 😂😂😂

IMG_20210914_223719_090.jpg
 
Decided to pick up a bigger 4s pack for the Typhon in hopes I'll be able to stop the high voltage sag I'm getting with the single 4s 5000mAh pack I'm running now. Also when I start having trouble gaining with the 5000mAh packs I'm running for 8s in the Limitless I'll pick up another one of these monsters and be good to go as also the G+ packs only go to 6000mAh packs so not going to buy new packs that are only 1000mAh more. Not bad at all with coupon was $80👍🏼
Screenshot_20210914-193345_Chrome.jpg
 
View attachment 169171
Those kids at fly sky are all class. Great packaging, and sweet looking finished product.
View attachment 169173
Now to decide what rigs get "noble'd" first 🤩
Isn't that going to be hard to set up, what with your burning hands, and you worrying about your sudden inexplicable male pattern baldness, and the lapse of yor bladder control? I tried to warn you. :ROFLMAO:
 
New rod ends for my turnbuckles.
Balls are machine-pressed in and barely have any slop. Should go well with my Lundsford titanium turnbuckles.View attachment 169295
Just so nobody is mislead into buying these. They DO NOT work with Lundsford turnbuckles(5mm). I'm drilling and tapping new threads.
16317514444766962301916307421982.jpg
16317515758589001625373767866820.jpg
 
Lunsford are 5mm threads you say? Well the rod ends do say M3 and M4 on the package, so might work well for other turnbuckles. Seem high quality?
Not sure if all lundsfords are 5mm but mine are.
Quality is debatable but seems solid enough. I wasnt looking for strength but more so eliminating slop. I picked these as the flush parts on balls seem the same as stock. My HR hubs have carbon fiber holders and I didn't want to force balls in between or tighten until it bent.
1631752646315323016621028667508.jpg

Fit seems so good that rod end looks installed and I'm holding it above
16317527858568526553131384024117.jpg

Ok, and I just had to test. .. At great risk to the only 5mm tap I have.I was impressed such thin pieces of aluminum took as much stress as it did
My opinion? It will take a real hard smack to break them. Decent quality because I got three un-oiled turns when I expected one to snap it. (This with proper 4.2 tap predrill bit)
16317537316374103643663235011715.jpg
 
Last edited:
Back
Top