Kraton Wheel hub assembly removal

[MattyIce 79]

Hey guys (and gals) here’s a pic below. I’m wanting to remove the hub and look at bearings. I have taken out the set screw in the middle but, still having problems removing where it attaches to the t bone.

Thanks fam

 

[Surchaufeur]

Use a solder iron to heat that screw out i will say the issue with the arrma are the locktite who is way too powerful

 

[Mr.Duke]

Push the pin out of the red hex then slide it off the axle.

 

[joostin420]

I usually use a small nail and hammer to lightly tap the fastening pin through the hub once the grub screw is loose.

 

[Camaroboy383]

If the pin is stubborn you can put a driver the same size as the pin against it and give it a sharp whack with another plastic screw chaser handle... it should drive the pin right out... then as mentioned above, just slide the hub off of the shaft..

 

[jondilly1974]

What do you mean by t-bone? Punch out that pin in the hex hub and it will come off.

 

[Camaroboy383]

What do you mean by t-bone? Punch out that pin in the hex hub and it will come off.

I'm assuming hes talking about the dogbone.. that's the way I took it anyway...

 

[jondilly1974]

I'm assuming hes talking about the dogbone.. that's the way I took it anyway...

But it shows a CVD in his pic ??‍

 

[MattyIce 79]

What do you mean by t-bone? Punch out that pin in the hex hub and it will come off.

Probably meant to say dogbone, but that was a post error. Excuse my rookie side