Hi,
My original wheelie bar snapped so I ordered a metal replacements but I've found that some screws have snapped in place.
I had a quick attempt at using a screw extractor drill bit but the ends aren't very flat and the drill bit wasn't biting into them.
Any suggestions or advice ? I am half considering ordering a new rear shock tower but I know that would a shameful move at this point
Thanks
Sam
My original wheelie bar snapped so I ordered a metal replacements but I've found that some screws have snapped in place.
I had a quick attempt at using a screw extractor drill bit but the ends aren't very flat and the drill bit wasn't biting into them.
Any suggestions or advice ? I am half considering ordering a new rear shock tower but I know that would a shameful move at this point
Thanks
Sam