When cooling a motor which way is better?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
Just set it up like a good PC/server airflow configuration with an intake fan near the front of the chassis to supply the motor fan with cool ambient air and then an exhaust fan near the back to remove the heated air. Or gear the truck and set the motor timing properly and then you don't have to worry so much about a hot motor.;)
 
I told you it was contrary to popular belief, but it's no good blowing hot air either if its hot no where to go 😂 I was purely commenting on flow.

Still, got the conversation going, didn't it 😉

Are you seriously doubling down on the misinformation you are spreading?
 
Last edited:
This has worked really well for my 6S Kraton:

IMG_0279.jpeg


2 x 40mm fans. Blows directly on the case of the Castle (which has the same rings as yours) with exhausts on the bottom.

Bs.JPG


Here's the CAD files:

https://www.thingiverse.com/thing:5086838

I have a new intake grill, will post a picture of that tomorrow. Temps stay very, very cool.

-ch
 
Last edited:
Old Thread: Hello . There have been no replies in this thread for 90 days.
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.
Back
Top