Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
If those RPM values are true, you may be overgeared. You should be hitting somewhere in the 40k range when maxed out. This shows 27k RPM. Are you choosing gearing in the Castle app? It should be left 1:1. Make sure to select 1650kv and 4 pole.Not sure why the hell this thing is pulling almost 400 amp?? Everything is perfect on the car. Bearings are new ceramic. Car drives absolutely perfect and straight. I even measured the resistance on the esc cables and they were 0.5ohms for both.
I am assuming the esc is not capable of my setup.
Battery I used was panther 6s 5000mah.
View attachment 151900
View attachment 151902
View attachment 151903
View attachment 151904
View attachment 151905
Drag brake should only works when throttle is in neutral. On the other hand Punch control is set to 90% which limits the acceleration, default is 0% (disabled) I would lower that number.Your speedrunning, right? In your screenshots you have drag brake enabled. Maybe disable it unless running in a vey short area where strong brakes are needed? Drag brake gives you peace of mind if you run out of radio range, but if you get off the throttle even a tiny bit it kills all momentum
I did not read the entire post but were the diffs mentioned? The front and rear should be locked (either shoe-glued or some other adhesive), or buying new diffs. And the center diff should be locked as well.A cap pack wont make it run faster, just cleaner what could make a few rpm's in difference. If you logs show more than 1.5v ripple a cap cap would be good.
You have the motor/esc/gearing to go a lot faster, so what is holding you back must be something else.
Just naming a few potential causes:
too short distance, aggressive throttle finger, friction in the drivetrain, overtightened wheelnuts, average batteries, high temps outside, aero/drag, ride height to low/high
Center diff locked is essential for speedrunning. Not for gaining more speed but to keep it on the road. It will flip at high speed.I did not read the entire post but were the diffs mentioned? The front and rear should be locked (either shoe-glued or some other adhesive), or buying new diffs. And the center diff should be locked as well.
Sorry if this was a repost.
Register and gain access to Discussions, Reviews, Tech Tips, How to Articles, and much more - on the largest Arrma RC community for RC enthusiasts that covers all aspects of the Arrma-RC brand!
Register Today It's free! This box will disappear once registered!