Senton Will 13t safe pinion fit on a Senton 3s?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
Only the mod .8
70A271E1-FD50-4D18-A415-F36E24271DFF.png

Part # ARA310996
 
If my memory serves me right, you can go down to 12T. I’m 99% sure I’ve run a 13T before.
 
That would depend on what motor your running.. not because of tooth count, but because of shaft style..

if your motor output shaft has the flat machined the full length then you can use one.. if not you will either be using a standard 5mm round bore pinion or you can continue the d grind off the end of the shaft...
 
Old Thread: Hello . There have been no replies in this thread for 90 days.
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.
Back
Top