Will the Outcast body mount/posts fit on the kraton?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
C5263D0B-1F03-42C9-B4FC-61D253A61221.jpeg


Ok. Installed the Outcast body posts and lined everything up. Time to paint.
 
Here is what the posts look like. I had to swap the front posts so they would be closer together, but when I have to change the height I have to remove the mounts to get at the screws. In the future I will use bodies where I can run them in the sides they are supposed to be at.

3A9622F3-40F8-41C7-AECF-E1BB0B3C96DD.jpeg
B8C35324-7792-495E-952F-90BFE9534544.jpeg
D4C39F36-1E36-4CE2-AA20-F3A7FDCE7AE3.jpeg
 
Ok great. I just wanted to make sure I wasn’t supposed to use every piece. That’s what was confusing me. Thanks again.
Hate to resurrect the dead, just wondering how this worked out long term? I need longer body mounts on my Kraton for my next Baja build and was looking for an alternative. Any structural issues/hard flex after you made the change?
 
Hate to resurrect the dead, just wondering how this worked out long term? I need longer body mounts on my Kraton for my next Baja build and was looking for an alternative. Any structural issues/hard flex after you made the change?

They’ve been great. Sometimes the rear screws will back out so I just check them before I run.
 
Old Thread: Hello . There have been no replies in this thread for 90 days.
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.
Back
Top