Kraton wing breaking

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.

hobo

Very Active Member
Messages
1,886
Reaction score
2,054
Arrma RC's
which wing have you found to be the most durable having trouble breaking them at the minute for the kraton 6s
 
Last edited:
Get a @3d-rc.myshopify.com wing mount and you will stop breaking your wing. Here's some video I did smashing on it to prove how tough it is and how much it saves your other parts also.
 
Surprisingly I have yet to break my stock one and still waiting to use the spare I have in my parts box. Those damn mount screws bend with any good hit though, even the strongest in small fastener class grade 12.9 ones. I have 20 left including the new ones I just swapped in after my last session. Hope that lasts me the summer.
 
I have the 3DRC but have not installed it. The T-Bone lower wheelie bar has done a great job of protecting the wing and pushing it back down keeping it from the wing. T-Bone purpose for me anyway was not reducing the wheelie to very low when it does it. It takes the stress of a rear landing however 3DRC is the cheaper easier route.
 
Cutting board wing on a 3DRC mount. :)
2022-0310-kraton-HW4985SL-M2CChassis-body-side-high.jpg
 
Old Thread: Hello . There have been no replies in this thread for 90 days.
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.
Back
Top