Outcast Wing Mount for Wingless Outcasts

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.

tobyjoe

Member
Messages
80
Reaction score
27
Location
NJ/NYC
Arrma RC's
assuming one wanted to remove their rear wing and wheelie bar, is there an aftermarket or Arrma part that fills the role of the wing mounts on the lower end?

Do folks just cut down the plastic parts?

I'm trying to tighten up the shape of my outcast for tighter technical tricks.
 
assuming one wanted to remove their rear wing and wheelie bar, is there an aftermarket or Arrma part that fills the role of the wing mounts on the lower end?

Do folks just cut down the plastic parts?

I'm trying to tighten up the shape of my outcast for tighter technical tricks.

Cutting down the parts is going to be the easiest. You can order the body mount set for the Senton. Tower is currently on back order.

http://www3.towerhobbies.com/cgi-bin/wti0001p?&I=LXEPDG&P=ML
 
I ditch the wing, but made a small block out of 1/2" TPR so there was something there to hit the ground before the rear tower. I did the same on my ERBEv2, but had ordered some black TPR by then.

2019-1227-Outcast-Max6-Body.jpg

2019-1207-ERBEv2-max6-ESCSide.jpg


I round the edges so they are less likely to dig into the ground, then they slide easier while still adding a "bumper".
 
Old Thread: Hello . There have been no replies in this thread for 90 days.
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.
Back
Top