Senton Worn out steering block 3s

[Olred1998]

What would make a steering block wear out excessively. only happened that bad on one side. I have gotten it clogged up with some moss but that was after one battery run.

 

[Camaroboy383]

Pull the hex off, you may find that bearing is smoked, letting the edge of the hex tear into the plastic

 

[Olred1998]

10-4 that’s kind of what I was thinking. The truck lives in my work van until Christmas. Got a hide it from my son until he gets his. LOL but I got a full tear down coming soon anyway. Got some Jim’s bearings and an Amazon special servo. And now steering blocks.....

 

[jondilly1974]

Bearings for shizzle my nizzle

 

[Rav3n]

Mine did the same thing. I just went ahead and did a full bearing set on tear down. Hasn’t happened since.

 

[Surchaufeur]

Stock bearing kinda suck can make plastic melt

 

[Skye Kaptain]

Metal bearings in a plastic housing, all it takes is a grain of sand or two or small bit of dust to cause the outer race to slip in the housing,sometimes one of my hubs will look like it's been rounded out by a stuck bearing even though the bearing itself still rolls freely.

 

[Outcastblxnut]

Your ripping your sons Christmas present around? Better throw some spare parts in his stocking ??‍

 

[Olred1998]

Haha no man. Got my kid his 1st real RC for Christmas. That's sitting under the tree. I found a slightly used senton 3S on Facebook for myself. was barely driven came with a 3s battery and charger.

 

[bicketybam]

Haha no man. Got my kid his 1st real RC for Christmas. That's sitting under the tree. I found a slightly used senton 3S on Facebook for myself. was barely driven came with a 3s battery and charger.

I got my kid a Turbo Man action figure. Tough to find. Almost had to settle for Booster.

 

[razorrc]

My kids are getting a green Arrma Fazon Voltage. For some reason I feel like eating McDonald's too.

 

[Cheapbastard]

I got my kid a Turbo Man action figure. Tough to find. Almost had to settle for Booster.