Hi folks, I’m back again trying to set my diff mesh.
I’ve got the rear diff all set installed in the car, but I can’t figure out how to get this front diff to stop binding when I put it in the car. The mesh is perfect in the yolk, but I kind of have to “squeeze” it into the upper bulkhead and it starts binding like crazy. This can be simulated outside of the car by pinching on the end of the yolk that goes around the driveshaft/output. I am aware that in the video, I haven’t tightened the yolk but it binds regardless. I suspect the yolk might be a little big and getting deformed when I put it in the car? TIA
I’ve got the rear diff all set installed in the car, but I can’t figure out how to get this front diff to stop binding when I put it in the car. The mesh is perfect in the yolk, but I kind of have to “squeeze” it into the upper bulkhead and it starts binding like crazy. This can be simulated outside of the car by pinching on the end of the yolk that goes around the driveshaft/output. I am aware that in the video, I haven’t tightened the yolk but it binds regardless. I suspect the yolk might be a little big and getting deformed when I put it in the car? TIA