Shock end & cap suggestions

[Slicktmi]

So i have the tekno part# tkr6140b i need to know the part number for the balls to fit in them and also do you guys do anything special for the plastic ball that goes on the cap side of the shock? Mine wear out and get sloppy then it starts smashing the cap. Any other bulletproofing shock hacks let me know

 

[Mongoose]

Any 6.8mm ball will work.

https://www.amazon.com/TEKNO-TKR5049A-Pivot-Balls-6-8mm/dp/B00DVNIG86

They offer different styles with different standoff’s too.

I bet if you were to find some Redcat branded ones they would be cheaper.

These will work on the top and bottom.

 

[Slicktmi]

Any 6.8mm ball will work.

https://www.amazon.com/TEKNO-TKR5049A-Pivot-Balls-6-8mm/dp/B00DVNIG86

They offer different styles with different standoff’s too.

I bet if you were to find some Redcat branded ones they would be cheaper.

These will work on the top and bottom.

Thank you I'll check em out I went to ace hardware today to find those aluminum sleeves people were taking about in the bomb proof shocks post but they didn't have any my luck lol

 

[Mongoose]

If you don’t mind paying shipping you can order them McMaster-Carr. They will definitely have them and you will have them next day usually.

 

[Slicktmi]

If you don’t mind paying shipping you can order them McMaster-Carr. They will definitely have them and you will have them next day usually.

I ordered kyosho w0202 5$ for 10 says they're 6.8mm just hoping the bolt size is correct i think 3mm?

 

[Mongoose]

Yep, they use 3mm screws.

 

[Frankai]

Sorry i know this is an early post but so these pivot balls fit in the arrma kraton/outcast shocks?