75D shore hardness, printed with PLA settings. Good for RC structural parts?
https://ninjatek.com/shop/armadillo/
Expensive though.
https://ninjatek.com/shop/armadillo/
Expensive though.
Armadillo Filament
- Thread starter kaladeth
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
links, including eBay, Amazon, and others.
I had 95D tpu from eryone which was relatively hard. And 95D overture which was way more flexible and soft. So there is quite a difference between some brands.
And I printed with 230C otherwise some layers would not stick to one another horizontally.
And I printed with 230C otherwise some layers would not stick to one another horizontally.
Last edited:
