Screw size in 6s motor cans?

[The Bean]

Somehow two of the three screws on the exterior of my stock 6s motor's can fell out. What sizes are these? I don't want to just drill in a new screw.

 

[parcou]

Somehow two of the three screws on the exterior of my stock 6s motor's can fell out. What sizes are these? I don't want to just drill in a new screw.

The 2.5 comes in different sizes. I bought these for a HobbyStar 4092 and 4082 motor. I think on some motors they can be countersunk, so it varies, not a one-size-fits-all all.

What I bought:
https://www.amazon.com/dp/B07H8JFHXP?psc=1&ref=ppx_yo2ov_dt_b_product_details

 

[slick2500]

Yeah M2.5 x 4 is the stock screw size make sure you use a drop of thread lock on them if you can I would change them to socket head screws.

 

[The Bean]

Alright, thanks! I'll have to order some of those, then.

Somehow screws all over my Noto loosened during its overseas transit. Even the wings screws, which are connected to lock nuts, became looser. I also found loose screws around the diffs, arms etc, and the grub screws holding in the pins that keep the axle connecyed to the wheel hexes somehow got loose causing the pin to fall out.

 

[slick2500]

Alright, thanks! I'll have to order some of those, then.

Somehow screws all over my Noto loosened during its overseas transit. Even the wings screws, which are connected to lock nuts, became looser. I also found loose screws around the diffs, arms etc, and the grub screws holding in the pins that keep the axle connecyed to the wheel hexes somehow got loose causing the pin to fall out.

Sounds like someone at customs tried to take it apart.

 

[The Bean]

Sounds like someone at customs tried to take it apart.

Yeah, but then the plastic I put over the body shelf was 100% intact and in place as I put it, and it had the original tape I put on the box