Talion Talion max battery size

[jjl5590]

Hi guys,

Will this battery fit in the Talion battery tray, or is it too wide?

https://hobbyking.com/en_us/graphene-4000mah-6s-45c-w-xt90.html

https://www.arrma-rc.com/rc-cars/latest/talion/blx/story-board

Thanks

 

[stuartd]

It’ll fit. The Turnigy HD 6s 5000 60c that’s 146*51*57 fits OK.

Here’s the Turnigy above in my Typhon. I don’t have a photo of it in my Talion but have used it often in there.

 

[Sledgehog]

According to the talion page it says max battery size is 158x48x70mm Not sure which is the height and width though.

Graphene is 146mm length, 51mm height, and 49mm width

 

[Erstadw]

According to the talion page it says max battery size is 158x48x70mm Not sure which is the height and width though.

Graphene is 146mm length, 51mm height, and 49mm width

48mm width and 70mm height.

 

[Sledgehog]

Well then that makes the graphene 1mm too wide but I'm sure it will fit "snugly"

 

[jjl5590]

It’ll fit. The Turnigy HD 6s 5000 60c that’s 146*51*57 fits OK.

Here’s the Turnigy above in my Typhon. I don’t have a photo of it in my Talion but have used it often in there.

cheers

 

[jjl5590]

The battery baaarely fits, it's a real squeeze. It's very difficult to push down the holder at the front due to the battery tray being pushed outwards. Hopefully I won't damage the lipo

 

[stuartd]

The battery baaarely fits, it's a real squeeze. It's very difficult to push down the holder at the front due to the battery tray being pushed outwards. Hopefully I won't damage the lipo

That's how I felt when I got the Turnigy HD 5000mah, 6s battery (which is the same dimensioons as yours except taller). I felt like it was too big, but after a few uses it does fit easier. I've ran it at least 20 times now between the 3 RCs and all's well. Might be that because the battery tray holder needs to slide down a little farther with yours it's more easilly noticed.