1/7 truggy

[Steveoarrma517]

Went to clean v2 talion an discovered how small inner rear wheel bearings are. I decided to beef things up a bit,an while I was at it,why not a little bigger foot print too. Got a Mojave chassis 38$ off eBay,an got all aluminium hot racing hubs an over size bearings. Also complete hot racing diff

housings .

M2C. Motor mount, ,center braces coming.servo mount needed to be turned,an esc location found

 

[SARRT8]

Is the Mojave chassis the same size as the Talion?

 

[bicketybam]

Is the Mojave chassis the same size as the Talion?

No. It's longer.

 

[SARRT8]

Thanks Bam.

 

[Steveoarrma517]

mocking up a body well be a challenge,. This is a proline c10 long body

Is the Mojave chassis the same size as the Talion?

longer.an if I use my hub extensions,foot print is almost as large as my xmaxx.?

 

[Steveoarrma517]

starting to get stronger

bigger bearings,next electronics

 

[Steveoarrma517]

Back together,now have mojave. Have some hub extenders coming too.Have four different sets of tires,but might buy some Mojave tires too for the he'll of it.

Size comparison to my xmaxx.no problem with dirt in this one.

 

[Steveoarrma517]

Don't buy these.pin hole in correct,leaves space between bearing an hub.

 

[Steveoarrma517]

View attachment 77233wide glid. Look great,but not made correct,pin hole location incorrect,space between bearing an extension.

 

[Steveoarrma517]

1st runs in today,very smooth car,handle well. Flipped over bank an ended up in a pond for min.pulled out an kept running,probably well lose a set of tires,otherwise should be ok.

 

[Steveoarrma517]

This 2020 proline ram body for erevo,,,savage body will fit on my 1/7 talion.