Vorteks 17mm hex adapter for 6mm diameter axles

[Honerbunch]

I'm currently using a vorteks converted to 17mm hexes with 3s typhon parts running on 1/8 buggy wheels no offset. I want to try widening the stance a bit more. Any ideas what hub extenders I can use? Most I see are for 8mm axles. I know redcat makes one for 6mm axles, but I can't buy it here in Belgium.

 

[KnowAir]

You can try using an extended version of these..
https://www.amainhobbies.com/traxxas-17mm-splined-wheel-hub-set-blue-4-tra5353x/p25831#tab-compat
Look under compatibility on Amain site, I'm pretty sure all those TRX vehicles have 6mm stubs so I have to think there's a plethora of extended hubs on the market for all those TRX models..
The drive pin hole could be an issue you may have to work around, not sure.
Good luck