Granite CVD shaft diameter

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
M

MSgt Granite

Fairly New Member
Messages
13
Reaction score
8
Has anyone else had this issue? I purchased a set of Arrma CVD's (ARAC3974). The shaft where the hex pin goes through, is about .5mm larger in diameter, and the hexes don't slide on. I know I can drill them, but I started looking for a bolt on solution. Is there any that y'all recommend?
 
Old Thread: Hello . There have been no replies in this thread for 90 days.
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

Rixxie33
Kraton Motor diameter help
Replies
2
Views
164
Rixxie33
Rixxie33
parcou
Big Rock Can I replace part of the CVD axle?
Replies
2
Views
99
parcou
parcou
razz007
Mojave What’s the LP fortress tyre diameter please
Replies
5
Views
979
razz007
razz007
T
Kraton Finish designing shaft cover kraton 4s v2.5
Replies
10
Views
365
Barmaleus
Barmaleus
Jrizzle69
Big Rock Gpm cvd drive axles install
Replies
4
Views
518
Jrizzle69
Jrizzle69
Back
Top