- Messages
- 401
- Reaction score
- 717
- Location
- East Bay, CA
- Arrma RC's
- Granite
- Kraton 6s
- Typhon TLR
- Infraction 4x4
- Thread starter
- #21
I think the printer just took a on me. It stopped mid print. And the hotend is no longer heating up. The thermostat works tho. I tried buying a new hot end. Installed yesterday.stoll getting "T0 sensor abnormal." I checked wires from hotend to base. I plan on opening up the bottom later tonight and checking the connections to the motherboard.
Any advice is much appreciated.
Honestly, I wanna buy a K1, but funds are a little tight atm. Hopefully, I can fix this issue easily.
Any advice is much appreciated.
Honestly, I wanna buy a K1, but funds are a little tight atm. Hopefully, I can fix this issue easily.