Kraton Servo height spacer (3d print)

[RC-Dude]

Had issues in the past with servo height on the Arrma 6s rigs. Some aftermarket servos like the Savöx 1210SG are just too high.

Made a little spacer that is higher than the original spacer. Adjust height as you need it on your slicer.


Arrma Spacer for Servo 6s rigs

 

[DoubLRRLIFE!8887]

Where would it go?

 

[morrjr71]

Where would it go?

You need two. They go between the servo tabs and the servo mount to raise the servo a bit so it doesn't hit the chassis.

 

[DoubLRRLIFE!8887]

You need two. They go between the servo tabs and the servo mount to raise the servo a bit so it doesn't hit the chassis.

Ohhhhh nice I had that problem with a savox I sold it because of this issue