- Messages
- 1,194
- Reaction score
- 3,307
- Location
- Ontario, Canada
- Arrma RC's
- Fireteam
- Granite
- Granite Mega
- Infraction
- Mojave EXB
- Nero
- Notorious
- Typhon 3s
When you are using a filament you've never used before what are your steps to get it dialed in.
Do you just try printing a part and adjust from there?
Do you make a bunch of calibration parts first? Do you have an order of how you like to do it? Ex. Temp than speed, then retraction,then flow etc?
I've printed a bunch so far and am still being surprised. Yesterday I printed a hollow cube to test the wall thickness. It came out a little oversized. Then out of curiosity I ran it again but 15 deg cooler and it printed right on size.
Do you just try printing a part and adjust from there?
Do you make a bunch of calibration parts first? Do you have an order of how you like to do it? Ex. Temp than speed, then retraction,then flow etc?
I've printed a bunch so far and am still being surprised. Yesterday I printed a hollow cube to test the wall thickness. It came out a little oversized. Then out of curiosity I ran it again but 15 deg cooler and it printed right on size.