@jondilly1974 and everyone that has tried this. The video is under the spur pic. Skip to 4:50. He said I have to grind/shave the stub in the slipper hub down. Instead of that, can I drill a bigger hole in the plastic spur?
3s spool question
- Thread starter Exc3l
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
links, including eBay, Amazon, and others.
The drill bit is guna grab. Either you guna break it or you guna rip your hand
- Thread starter
- #3
Do u mean it's going to grab the spur and it's just going to spin in my hand and rip it up? That's not a problem! I have a vice so I think I am good...
Go for it, you risking breaking it
jondilly1974
Speed running apprentice, motor Slayer 🤘
Lifetime Premium!
Premium Member
Excellence Award
Build Thread Contributor
- Messages
- 26,134
- Reaction score
- 38,840
- Location
- Toledo, OH
- Arrma RC's
- Granite
- Infraction
- Kraton 6s
- Kraton EXB
- Senton 3s
- Typhon 6s
- Typhon 3s
A drill press would be best.
- Thread starter
- #6
I have a drill press in the garage. I have thought about it. Maybe it's time for me to get a bench grinder!
How did you come out with gear?
- Thread starter
- #8
Its not my idea. Its rich duper bash's
Were you able to grind the stubs down?
- Thread starter
- #10
No, I haven't done anything yet.....I will prolly cut the stub off with a small hand saw I use for cutting plexiglass. Since the slipper hub fits in there perfectly in the spur it doesn't matter. the stub doesn't do anything.
