How do I remove the push ball from a broken connector and put it in a new one?
Broken pushrod connector
- Thread starter Cheez
- Start date
Put a screw or something in the eye hole, grab it with a pair of pliars, and twist it out. You could also just cut the plastic with a pair of side cutters.
you can then squeeze the new one in with the pliars.
you can then squeeze the new one in with the pliars.
- Thread starter
- #3
Thanks!
Broke my first rod connector under less than aggressive conditions. A little concerned about that.
Broke my first rod connector under less than aggressive conditions. A little concerned about that.
As soon as I break one, I'll figure out a solid solution for everyone
- Thread starter
- #5
Thanks
