Kratonpilot77
Fairly New Member
- Messages
- 6
- Reaction score
- 7
Just finished building my 6S EXB, with CC Monster X 8S /1717 1650kv combo. Spektrum DX5C transmitter and SR6100AT Receiver. In case it matters, I have SPMA95871 Telemetry sensor plugged in as well. When trying to calibrate the ESC, holding throttle down on transmitter, batt disconnected and switch off to ESC, when connecting the battery, then turning ESC on with trigger still pulled down, I just get a flashing red light, no beeps. Doesn't matter how long I hold the throttle down. As soon as I let go of the throttle, the ESC powers up and receiver lights uup/ powers on. I start getting beeps as if starts the calibration process, bot only after releasing throttle.
I attempted to go through the calibration process even though it didn't start correctly, but before I was even finished, the motor started spinning. It does respond to forward and reverse but yellow light now on solid and flashes red with 3 fast beeps over and over. I've tried multiple times, & same result. Help? Here's photos of the install showing wiring I also used Castle B-link to program ESC. I don't think it matters, but I have a gensacearespammers 6S & 4S Lipo batteries, with 4S currently installed. I have a video of it as well but can't post it on the Forum, of course.
I attempted to go through the calibration process even though it didn't start correctly, but before I was even finished, the motor started spinning. It does respond to forward and reverse but yellow light now on solid and flashes red with 3 fast beeps over and over. I've tried multiple times, & same result. Help? Here's photos of the install showing wiring I also used Castle B-link to program ESC. I don't think it matters, but I have a gensacearespammers 6S & 4S Lipo batteries, with 4S currently installed. I have a video of it as well but can't post it on the Forum, of course.
Last edited: