Typhon Chassis protection?

[raynist]

I built a ramp/jump out of plywood and painted it with an outdoor deck paint. The paint is very thick and textured with sand. It is almost like asphalt sealer and feels like sandpaper. It works great for all of my vehicles. I used the Typhon today - it slices through the air like an arrow! At one point it flipped over and I saw the chassis was really scrapped up at one point in the front and rear. almost like it was filed down.

Are there some protective skids I can put on the bottom to prevent this?

Thanks
Ray

 

[Engineer]

Based on those wear points, an RPM front bumper and rear skid plate should work for you.

https://www.rpmrcproducts.com/shop/...kid-plate-for-the-arrma-kraton-durango-dex8t/

https://www.rpmrcproducts.com/shop/...or-arrma-durango-8th-and-10th-scale-vehicles/

 

[raynist]

Perfect!!!

Thank you!

Just ordered!

 

[jondilly1974]

Can I recommend a TBone rear bumper instead of a skid? Has a skid plus rear protection too

 

[raynist]

Can I recommend a TBone rear bumper instead of a skid? Has a skid plus rear protection too

definitely!!

it looks like the rear Basher number is out of stock

 

[jondilly1974]

definitely!!

it looks like the rear Basher number is out of stock ☹

Check daily. They reload all the time. I had to settle for a red one but still got it.

 

[Engineer]

definitely!!

it looks like the rear Basher number is out of stock ☹

If it's out of stock, sign up for the stock request notification - I was told it helps drive their demand system for production.

 

[K-BASH]

Got These HR ones on senton and notorious. Should fit,same chassis.they protect the most important parts

 

[PirateRC]

You could also make 2 side strip grind bars out of some nylon ware plate run 2x 15x8mm strips and miter ends to better flow ?that will prevent body scratches
Or even 3d print some ?
Or even look at raising ride hight