Hi all, first post here but been lurking a bit since I picked up my Vorteks the other week.
I had taken everything apart to clean and upgrade to the RPM arms, and I noticed that the front section of the chassis bends upward slightly. I could see this being for a little extra ground clearance but I could also see it being bent.
I've never crashed hard into anything, but it for sure has taken some tumbles/cartwheels.
The rear aluminum crash bar sits level/parallel with the chassis. The front does not.
If it is bent, is there anything to fix besides a new chassis? I have a protection plan on it but didn't think I'd be using it this quick
I had taken everything apart to clean and upgrade to the RPM arms, and I noticed that the front section of the chassis bends upward slightly. I could see this being for a little extra ground clearance but I could also see it being bent.
I've never crashed hard into anything, but it for sure has taken some tumbles/cartwheels.
The rear aluminum crash bar sits level/parallel with the chassis. The front does not.
If it is bent, is there anything to fix besides a new chassis? I have a protection plan on it but didn't think I'd be using it this quick