wrenchinsasquatch
Member
I had the jumper in LiPo mode on the ESC from the last use and hooked up a NiMH battery. It moved a little, stopped then the ESC started beeping with a flashing red light. Is it hooped? This is in a bone stock Granite Boost.
Granite Did I fry my ESC?
- Thread starter wrenchinsasquatch
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
links, including eBay, Amazon, and others.
- Messages
- 6,175
- Reaction score
- 9,041
- Location
- Illinois
- Arrma RC's
- Fireteam
- Infraction
- Limitless
- Kraton EXB
- Talion
- Typhon 6s
- Typhon TLR
It just stopped because it thinks the battery is dead…
wrenchinsasquatch
Member
- Thread starter
- #4
I tried that too. Still beeps. I disconnected the battery between switching the jumper too.
wrenchinsasquatch
Member
- Thread starter
- #5
I don't know if it's done or not but I contacted Horizon customer service. They didn't even try to diagnose it, they're just sending a new one out. 
- Messages
- 6,175
- Reaction score
- 9,041
- Location
- Illinois
- Arrma RC's
- Fireteam
- Infraction
- Limitless
- Kraton EXB
- Talion
- Typhon 6s
- Typhon TLR
Yeah that’s how they roll most of the time. Great customer service.I don't know if it's done or not but I contacted Horizon customer service. They didn't even try to diagnose it, they're just sending a new one out.
Eno
Active Member
Did you also restart the ESC?
mtrapani
Fairly New Member
- Messages
- 13
- Reaction score
- 7
I am very new to RC cars. I bought a Granite in March, ran it about 4 times. Went to run it a fifth time and last week as I turned it on the ESC is flashing red. No throttle or steering. Arrma sent me a new ESC and same issue. I am unable to bind no matter what I do. Arrma has ghosted me since. So now I have a $500 paperweight.
