- Messages
- 10,194
- Reaction score
- 25,187
- Location
- TENNESSEEESSEEEEEE
- Arrma RC's
- Limitless
- Mojave
- Typhon 6s
- Thread starter
- #801
Octura 1640 with some tip cup and a bit of increased camber roll creating a lower lift profile can be a killer prop. sharpened and balanced with heat treating prior to use is key.
In my many years of R/C boat racing, prop cupping / mods was a part of it. Having prop cupping ball jigs. dial indicator measurement fixtures & heat treat kiln etc to do so was part of the obsession.
Great fun .. but a Very very very deep rabbit hole to grasp all the specifics of the hobby & good for you diving in to figure it all out
Thats awesome!
I did buy a cupping rig and hammer setup, but didn't get as deep into it yet for a kiln.
Last edited: