Velodromed
Snatching defeat from the jaws of victory!
Premium Member
Excellence Award
Build Thread Contributor
- Messages
- 7,758
- Reaction score
- 13,924
- Location
- San Antonio, TX
- Arrma RC's
- BigRock 4x4
- Granite
- Kraton 6s
- Kraton 4s
- Notorious
- Outcast 4s
- Vorteks
- Voltage
- Infraction 4x4
Hey buddy, that’s an issue I haven’t had yet. I’ve a Noto, Kraton and five, 3s cars and the pinions on them aren’t tucked in as far.. Those grubs come in 3 & 4mm also. I only like the 5mm for the deeper hex, which helps it not strip out. It’s the flat tip that makes the main difference though in securing the pinion. Compare them to the normal cup tip and you’ll see what I mean.Hey Boss question on these
The shaft is long, so how do you use them with your pinion if the set screw is this long? With the FireTeam the set screw is pushed down to the end of the motor shaft, so it is under or within the motor mount bracket. It would not make a full turn being this tall unless I see this wrong
Thx
60Pcs M4x4mm Grub Screws Flat Point Socket Set Screws High Tensile 12.9 Grade Steel Black Oxide (60Pcs, M4x4mm) https://a.co/d/9Yy4TLT