Hi everyone, this is my upgraded/modified Arrma granite 3s blx Below will be a list of my upgrades/ mods and my opinion of each of them. Enjoy?
Typhon 6s shocks-front/rear... Best upgrade I’ve made yet, performance and strength is superb
Fast eddy bearings... If you buy any Arrma this should definitely be your first upgrade
GPM tie rods, steering blocks and bell crank... Much against the advice of @slick2500 i went ahead and got the tie rods. They have been great, they removed the slop coming from the plastic pivot balls and have survived some pretty nasty hits. The bell crank on the other hand just looks nice-that’s about it. Steering blocks are good also.
Kimbrough large extra strong servo saver... much better than stock, recommended upgrade.
Servo... ADS 15M, decent torque, A little on the slow side tho. Only 10 bucks at Jenny’s
Rear mudgaurds... Cut up the lid of an old icecream container and attached it with some screws I had laying around. they work great ?
Outcast 4s centre chassis support. Just got this for the bling....??????but it does its job well...
Custom painted body reinfored with tape and glue on the inside... Colour= Tamiya ps59 dark metallic blue
Arms and bumpers soaked in WD40... Haven’t broken one since doing this trick.
MX-28 badlands are definitely in my future.
This sums up the end of my upgrades, I hope this thread has helped you decide your next upgrades for your Granite.
Post any upgrades I have missed or you recommend.
Thanks and have a good evening?
Typhon 6s shocks-front/rear... Best upgrade I’ve made yet, performance and strength is superb
Fast eddy bearings... If you buy any Arrma this should definitely be your first upgrade
GPM tie rods, steering blocks and bell crank... Much against the advice of @slick2500 i went ahead and got the tie rods. They have been great, they removed the slop coming from the plastic pivot balls and have survived some pretty nasty hits. The bell crank on the other hand just looks nice-that’s about it. Steering blocks are good also.
Kimbrough large extra strong servo saver... much better than stock, recommended upgrade.
Servo... ADS 15M, decent torque, A little on the slow side tho. Only 10 bucks at Jenny’s
Rear mudgaurds... Cut up the lid of an old icecream container and attached it with some screws I had laying around. they work great ?
Outcast 4s centre chassis support. Just got this for the bling....??????but it does its job well...
Custom painted body reinfored with tape and glue on the inside... Colour= Tamiya ps59 dark metallic blue
Arms and bumpers soaked in WD40... Haven’t broken one since doing this trick.
MX-28 badlands are definitely in my future.
This sums up the end of my upgrades, I hope this thread has helped you decide your next upgrades for your Granite.
Post any upgrades I have missed or you recommend.
Thanks and have a good evening?