Senton need Help with my arrma rc car

[Muhammed ocal]

So theirs a problem with my senton 3s Its go a problem when I press throttle red light flash then when I realise green car doesn’t go steering works fine and when I try calibrate I press set then turn on it makes a clicking noise and red light flashing PLZ helppppp

 

[SrC]

Hopefully you have a Volt meter with a continuity test. Power off with no Battery connected, check for continuity between each motor phase wires(3) and positive battery connector, then do the same with negative wire connector. If you get continuity between any of the Motor's phase wires to Neg or Pos(short) and not open, then your ESC is bricked. Either the ESC Capacitors are fried, or the Mosfets are fried. An inexpensive Digital Vom is good to have. It speeds up trouble shooting. Good luck.

 

[jondilly1974]

Are you running a 3S pack? If so, you have a common ESC firmware glitch. Call Horizon for a replacement.