Typhon Rear suspension rear guards

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.

FastMann40

Active Member
Military Veteran
Messages
156
Reaction score
252
Location
West Coast Ca
Arrma RC's
  1. Senton 3s
  2. Typhon 6s
Screenshot_20231002_190405_Photos.jpg

I have a few guys who I short track race with and they run with the mp9s. Does anyone know if you can put anything on the Typhon 6s? I'm also looking for an acceptable front bumper for the typhon.
 
That was an easy one.;)
Some guys just fab them out of sheet Lexan ( paint them) or use plastic.
But those shown above come Specifically with the TLRT Typhon and will fit the Standard 6s Typhon as well. Plug and play. Screws sold separately, if I am correct.
 
That was an easy one.;)
Some guys just fab them out of sheet Lexan ( paint them) or use plastic.
But those shown above come Specifically with the TLRT Typhon and will fit the Standard 6s Typhon as well. Plug and play. Screws sold separately, if I am correct.
Thank you very much.
 
I've often seen these and am thinking about getting some but aren't they suppose to cover the CV?
 
I've often seen these and am thinking about getting some but aren't they suppose to cover the CV?
We raced on a track that about 15 minutes prior had been rained on. I didn't have these at.the time, and my whole rear end was covered. I had a few friends who had the guards, and theirs were free of debris and rocks. Since getting the guards, it's help keep it protected.
 
Old Thread: Hello . There have been no replies in this thread for 90 days.
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.
Back
Top