There seems to be a lot of this type of symptom and I've tried many of the suggestions to no avail. Still waiting on support to respond but figured I'd ask in case someone can suggest something else to try.
I picked up my Kraton today and when batteries were first connected I did have throttle control and steering after I bound the TX to the RX. I had trouble getting the RX cap back on correctly so I ended up taking out the entire RX box and unplugging the RX to figure out why the cap wasn't going on. After I figured that out I reinstalled the RX and now when turning the car on all I see are flashing red LED on the ESC, throttle control doesn't work but steering does. I have not actually driven it, just a few throttle blips going through the original setup.
1. Resetting the TX does not help.
2. Tried factory resetting the ESC per instructions but this doesn't seem to work, holding the set button down for 4 seconds after turning car on does not show a red/green LED like stated.
3. I have tried following throttle setup to no avail, it appears it goes into setup but for the neutral point when I hit the set button it does not switch to set forward and then reverse, set button doesn't do anything.
4. The two cables going into the RX are same as before, the shorter of the two cables are connected to the "B" row of pins and the second longer cable is connected to the "1" row of pins.
I picked up my Kraton today and when batteries were first connected I did have throttle control and steering after I bound the TX to the RX. I had trouble getting the RX cap back on correctly so I ended up taking out the entire RX box and unplugging the RX to figure out why the cap wasn't going on. After I figured that out I reinstalled the RX and now when turning the car on all I see are flashing red LED on the ESC, throttle control doesn't work but steering does. I have not actually driven it, just a few throttle blips going through the original setup.
1. Resetting the TX does not help.
2. Tried factory resetting the ESC per instructions but this doesn't seem to work, holding the set button down for 4 seconds after turning car on does not show a red/green LED like stated.
3. I have tried following throttle setup to no avail, it appears it goes into setup but for the neutral point when I hit the set button it does not switch to set forward and then reverse, set button doesn't do anything.
4. The two cables going into the RX are same as before, the shorter of the two cables are connected to the "B" row of pins and the second longer cable is connected to the "1" row of pins.