mikeshandssay
Member
- Messages
- 177
- Reaction score
- 88
- Arrma RC's
- Limitless
- Senton 6s
So I put in a Robinson Racing MOD 0.8 23T gear. The stock pinion had to be drilled out cause the set screw stripped(Thanks Arrma for using so much Loctite). This left a divot in the motor shaft so now the set screw wants to be in this divot. This mis-aligns the pinon and spur so only about 80% of the pinion is touching the spur.
I know I should get a new motor - but buying a new spur gear just seems way cheaper.
What should I do about this spur gear? Upgrade to metal since they don't overlap 100%? Use the stock and just slowly chew them up?
I want to get a Hobbywing Xerun XR8 SCT Brushless ESC/3660SD G2 Motor Combo (3200kV) but they are like $180
This motor would be a direct fit right?
I know I should get a new motor - but buying a new spur gear just seems way cheaper.
What should I do about this spur gear? Upgrade to metal since they don't overlap 100%? Use the stock and just slowly chew them up?
I want to get a Hobbywing Xerun XR8 SCT Brushless ESC/3660SD G2 Motor Combo (3200kV) but they are like $180
This motor would be a direct fit right?