Kraton Sleeve the Top Brace

[JRunner01]

I used a little dremel cut off wheel. Just slip it over the brace, it’s nice and snug. You have to cut a little plastic out of your center tower to allow it to pass thru. On the ends you can use some shrink pipe or a tiny dab of hot glue to keep it from sliding around.

Thanks !

 

[bicketybam]

Back in stock.

What do you guys do to install these? Cut to length needed I imagine for all 3 braces \ rods and install? What do you cut them with? Hacksaw should work right?

I used a little pipe cutter that I had and it took forever. I them switched to a Dremel cut off wheel like @Jimbobjr

 

[JRunner01]

I used a little pipe cutter that I had and it took forever. I them switched to a Dremel cut off wheel like @Jimbobjr

I just realized my die grinder will knock it out

 

[bingbong15]

Back in stock.

What do you guys do to install these? Cut to length needed I imagine for all 3 braces \ rods and install? What do you cut them with? Hacksaw should work right?

I used a hack saw. Cut through it like butter. Nice and straight.

 

[Droste78]

PSA-Any time you are mechanically working composite structures, use a dust mask! Of the three, fiberglass is the worst, but your sinuses and lungs will not find any of them to be agreeable!