Outcast Spektrum 120amp ESC neutral calibration

[Luigibell78]

I was wondering about the ESC programming for the transmitter.

i have the arrma outcast 4s with the spektrum 120amp RTR esc,

I switched out the transmitter and receiver to a different brand. and typically in the past (with hobbywing branded esc) you needed to set the neutral point of the radio/receiver by holding the set button and setting full, forward and brake and neutral.

i tried that combination of settings and it does not work....and I do not see any mention of that in the manual either?

Does this ESC not require that type of calibration?

 

[Senton_Prime]

Did you read the manual thoroughly!?

 

[Luigibell78]

i tried that....doesn't seem to be working...... but i will try again....thanks

Did you read the manual thoroughly!?

View attachment 242787

Haha... thanks I missed that completely...and I wasn't holding the set button long enough...got it

 

[Senton_Prime]

Just curious.. what setup did you go with for the tx/rx!?

 

[Luigibell78]

Just curious.. what setup did you go with for the tx/rx!?

I have a radiolink rc6gs v2. The trigger response is much better than the original specktrum.

 

[Senton_Prime]

I have a radiolink rc6gs v2. The trigger response is much better than the original specktrum.

Right.. anything is better than the slt3!!